Stormwater Drainage and Retaining Wall Construction in Riverstone, NSW
What is included
What Is Included in Our Stormwater Drainage and Retaining Wall Construction
- We walk the site to see where rainwater collects, where it needs to go and where the ground slopes.
- Pipe runs, pit positions and wall lines are marked out on the ground with paint and pegs.
- Before digging, we check for buried services such as water, gas, power and telecommunications cables.
- Trenches are dug to the pipe fall, and a bed of fine gravel or sand is laid and levelled.
- Pipes are laid to a steady fall, joined and connected to pits, then backfilled and compacted in layers.
- For a retaining wall, the footing is dug level and the wall is built up in stages.
- A drainage pipe and gravel are placed behind the wall so water does not build up against it.
- We backfill, tidy the ground and run water through the new drains to check that it flows away.
Why us
Why Choose Us for Stormwater Drainage and Retaining Wall Construction?
Accountable for every job, long after the day
Every stormwater drainage and retaining walls job is done by the people who will still be here next year.
Tested and signed off before we leave
Everything we touch on your stormwater drainage and retaining walls is tested before we go, you get walked through exactly what was done.
Local asphalt contractors, not a call centre
An asphalt contractor answers the phone and the same faces come back if the job runs over a day.
How the job runs
Drainage starts with where the water goes
Describing the problem
Tell us where water pools or where the ground is slipping, and what sits below it, such as a driveway, shed or neighbour's fence. Say whether you need drainage, a wall or both. We also ask about the height of the wall you have in mind, because taller walls may need an engineer's design and a council approval first.
Walking the fall of the land
On site we look at where the water comes from and where it can go, and that is not always the nearest drain. We mark pipe runs and wall lines on the ground. Buried services and ground conditions can change the plan, and we tell you if they do.
Digging, laying and handover
We dig the trenches or footings, lay the pipes or build the wall, and backfill in layers. The drains are tested with water so you can see them work. Spoil and offcuts are cleared away. We walk through the finished work with you before we leave.
Common questions
Frequently Asked Questions
Which suburbs do you cover?
We work across Sydney and the surrounding suburbs, and the service areas page lists twenty-one of them, from Windsor and Richmond in the north-west to Liverpool and Narellan in the south-west. If yours is not listed it is still worth asking, because the list is where we work most often rather than a boundary.
What hours are you open?
We are open Monday to Friday, 8am to 5pm, and closed on Saturday and Sunday. Ring in those hours and tell us the suburb and what the surface is used for.
What is the difference between resurfacing and mill and fill?
Resurfacing lays new asphalt over the existing surface after it has been cleaned and repaired. Mill and fill first grinds off the top layer of old asphalt, then lays new asphalt in its place, which keeps the finished level the same and removes what has worn out.
How do I know if I need a patch or a full rebuild?
A surface that is only worn or lightly cracked can often be patched or resurfaced. Cracks in a network, soft spots that move under a foot, or water that keeps coming back usually mean the base under the surface has failed, and then the base has to be dug out and rebuilt.
How long before I can drive on new asphalt?
Asphalt has to cool before it takes traffic. How long that takes depends on how thick it is laid, the weather and the mix, so we tell you on the day when it is safe to use rather than giving a number here.
Can asphalt be laid in the rain?
No. Rain and a wet surface stop the new asphalt bonding to the layer under it, so a job planned for a wet day is moved to the next dry one.
What is spray sealing and when is it used?
Spray sealing sprays a layer of bitumen onto a prepared surface and covers it with stone chips that are rolled in. It is used on rural roads, long driveways and low-traffic roads where a full asphalt surface is more than the job needs.
Do you work on driveways as well as roads and car parks?
Yes. Asphalt driveways, car parks and roads are all on our service list, and so are the roadworks and civil work that sit underneath them.
Do I need council approval before the work starts?
Work on a public road or footpath usually needs permission from the road authority first. Work on private land can need council approval depending on the job. Describe the site when you call and we can tell you what to check.
What should I have ready when I call?
The suburb, roughly how big the area is in metres, what the surface is made of now, what it is used for and what is going wrong with it. That is enough to start a conversation about the job.
Do you do drainage as well as surfacing?
Yes. Stormwater drainage and retaining walls are on our service list, and they are often part of a surfacing job, because water that sits on or under a surface is what breaks it up.
What is asphalt profiling and road milling?
Profiling uses a milling machine to grind the top off an existing asphalt or concrete surface to a set depth and level. It removes a worn layer, corrects the shape of the road, or gets the surface ready for new asphalt.
Can old asphalt be recycled?
Yes. Old asphalt that has been milled or broken out can be crushed and used again as recycled road base, so it does not all have to go to landfill.
Do you build sports courts?
Sports court asphalting is on our service list. Tell us the type of court and the size of the area, and whether it is a new base or an existing court that needs resurfacing.
What does it cost?
The cost depends on the size of the area, how thick the surface is laid, the condition of the base under it and how easy the site is to reach. No two sites are the same, so we do not publish prices. Describe yours and we will talk through what drives it.
Related work
Other jobs we get called out for
sports court asphalting
Sports court asphalting lays a smooth, level asphalt surface that sheds water for basketball, netball, tennis and multi-use courts, carried out across Sydney and its western, north-western and surrounding suburbs.
Read moreasphalt recycling and recycled road base
Asphalt recycling takes old asphalt up off a surface so it can be reused as recycled road base for new driveways, car parks and roads, carried out across Sydney and its western, north-western and surrounding suburbs.
Read morecommercial asphalting
Asphalt surfacing for business sites such as yards, loading areas and access roads, carried out across Sydney and its western, north-western and surrounding suburbs.
Read moreServing Riverstone and The Surrounding Areas
Where we work
Ready when you are
Book Stormwater Drainage and Retaining Wall Construction in Riverstone Today
Tell us where the water collects or the ground is slipping, and roughly how many metres long the area is. A short description is enough to get us started. We will ask the rest on the phone.
0468 075 505Monday to Friday 8am to 5pm, Saturday and Sunday closed
Not urgent? Send us the job instead
